Posted 3/25/2021 07:48 (#8914531 - in reply to #8913926) Subject: RE: Disabled transmission on jd 8310
West Central Iowa
2013 | Zwcad Portable
Emergency Field Edits: If a technician needs to make a quick change to a floor plan at a job site using a borrowed computer.
Features like Smart Mouse , Property Palette , and QuickCalc were already mature in 2013. The Grip Editing functionality is responsive and intuitive, even on low-resolution screens. zwcad portable 2013
I thought I would add this just in case someone runs into this problem WITHOUT having a fuse in the DIA location.
The DTAC solution # is 71449 dated 12-22-2010.
Solution Summary: 00/10/20 W/T tractor goes into diagnostic mode on its own.
Complaint or Symptom: Tractor goes into Diagnostic mode while operating in the field. Corner post display stops showing engine RPM and displays DIA while engine is running. Tractor can be shut off and restarted to return to normal operation. Circuit 312 acquires enough voltage from other circuits to place controller into diagnostic mode without a fuse in diagnostic mode position F10.
Solution: Insert a male spade terminal into diagnostic fuse F10 for circuit 312 (non-powered side). Connect the other end of this wire to a ground terminal in the power strip. This prevents circuit 312 from causing controllers to go into diagnostic mode without a fuse installed in position F10.
CAUTION: Make certain to use a voltmeter to identify which side of fuse holder F10 does not have 12 volts applied to it. Non-powered side of fuse F10 is connected to circuit 312.
I had a 8410 a couple of years ago with this problem and a ground wire cured it.
Disabled transmission on jd 8310
